Basic SkyView Display Operation
SkyView System Installation Guide - Revision K 3-9
In Flight Setup Menu
This menu contains links that may be useful during flight:
ADAHRS Source Selection…
Flight Angle Pitch Adjust…
AOA Calibration…
Autopilot Setup…
Enter Full Screen Setup Menu…
Note that this menu occupies only half of the screen and that all of the links in the In Flight
Setup Menu are accessible via the Setup Menu.
Setup Menu
This menu contains links to system configuration options:
System Software
System Setup
Local Display Setup
PFD Setup
EMS Setup
Map Setup
Autopilot Setup
Transponder Setup
Traffic Setup
Hardware Calibration
Note that this menu occupies the entire screen. The menus above have menus of their own. The
information in this section contains information on the purposes of each of the above menus as
well as a list of each menu's respective menus and their functions.
Pages and wizards that require users to do something have explicit onscreen
instructions. Most actions are simple enough and onscreen instructions are more
than adequate. In these cases, explicit instructions are not contained in this guide.
In cases where onscreen instructions are not present, instructions are included in
this guide.
System Software Menu
You must have a USB flash drive that is recognizable by the display in one of the
USB slots to open this menu. All of the functions under this menu either write to or
read from the flash drive.
Detailed instructions for all of the menus listed below are included in the Firmware
Updates and File Operations Section of this guide.
The Software System Menu contains links to the following wizards:
To Next Page
Loading...
