SV-D700 / SV-D1000 Installation and Configuration
SkyView System Installation Guide - Revision K 4-17
SkyView Audio Output Settings
Go to SETUP MENU > SYSTEM SETUP > AUDIO SETUP to configure audio output settings. Most
of the items in this menu control whether the audio output for a particular alert or alert
category is played or not. The settings that can be adjusted here that are not voice alert toggles
are:
Volume Control / Test: Sets the volume level. While in this menu, sound is played
continuously so that proper audio connectivity and volume levels can be confirmed.
o In this menu only, audio is only outputted from the actual display that is in the
setup menu. This allows one to troubleshoot the physical audio connections. In
actual operation, only one of the displays transmits audio at a time. Which
display happens to be transmitting is automatically managed by SkyView. Since
all displays’ audio outputs are connected together (and to the intercom or audio
panel), this is transparent in actual use.
Boot Sound: When set to ON, the system will say “Dynon SkyView” when it first starts
up.
Angle of Attack: This sets a pulsing, progressive tone that increases in frequency, similar
in nature to a conventional reed type aircraft stall warning sound to a reed-type stall
warning sound, although it is much more predictable in its progression. It can be set to
start its pulsing tones at either the border of the yellow/green marks on the AOA bars,
the middle of the yellow, or the yellow/red border. The pulsing tones start at the level
selected and get progressively quicker and closer together until a solid tone is played at
critical AOA (in the red.)
o Inhibit AOA Below Airspeed: Allows you to set an airspeed below which no AOA
tones are played. This helps prevent nuisance alarms while on the ground and
taxiing, especially in tail draggers.
Discrete Input Connections
Discrete input connections are currently not supported in SkyView. A future firmware update
will enable this functionality. Do not connect anything to these pins at this time.
Reserved Connections for Future Use
Do not connect anything to unspecified D37 connector pins (directly or using the display
harness). These are reserved for future use.
Display Setup
You can access important information about a SkyView display as well as configure serial ports,
characterize your display backlight behavior and specify other display-specific settings.
How to Access Display Hardware Information
Enter the Display Hardware Information Page (SETUP MENU > LOCAL DISPLAY SETUP > DISPLAY
HARDWARE INFORMATION) to access important display hardware information. This menu
To Next Page
Loading...
