Accessory Installation and Configuration
SkyView System Installation Guide - Revision K 14-13
General Installation Recommendations
Connect the female BNC to the male BNC included with your capacitive fuel level sensor.
Connect the wires as shown in the table to an enhanced general purpose input on the SV-EMS-
220. If you need to extend the wire beyond the supplied length, we recommend avionics grade
22 AWG wire with Tefzel® type insulation.
Refer to the Fuel Level Sensor Section for EMS pin-out information when connecting this
product to your SV-EMS-220.
You must configure the input type on the SV-EMS-220 to capacitive sender before calibrating
this product. Refer to the EMS Sensor Definitions, Mapping, and Settings Section for
configuration instructions and the EMS Sensor Calibration Section for calibration procedures.
Any one or two
of 8,22, or 31
Capacitance converter
output to EMS fuel level
input (0 Vdc to 5 Vdc)
12 Vdc Power (normally
used for fuel flow)
Table 47 – Capacitance-to-Voltage Converter Wiring
To Next Page
Loading...
