Appendix A: Maintenance and Troubleshooting
SkyView System Installation Guide - Revision K 15-9
Ensure that the GPS serial port’s parameters are configured correctly. Go to the Serial
Port Setup Menu (SETUP MENU > LOCAL DISPLAY SETUP > SERIAL PORT SETUP > SERIAL
PORT # SETUP) and check the input device, function, baud rate, and output device
properties of the port. This menu also contains serial transmit (TX) and receive (RX)
counters. These show activity on the transmit and receive lines of that port and can
indicate if the GPS is at least active on that port. Reference the SV-GPS-250 Serial
Connection Section for SV-GPS-250 serial port settings. Also reference the Serial Devices
Section on page 4-11 of this guide if a comprehensive explanation of SkyView serial
connections is necessary.
Engine Sensor Does Not Show Up Onscreen
Make sure the sensor is installed, defined, mapped, and configured according to the
instructions found in the SV-EMS-220 Installation and Configuration Chapter.
To Next Page
Loading...
