F9, F9 Express Fetal & Maternal Monitor User Manual Introducing the FTS-3 Fetal Telemetry
System
- 45 -
NOTE:
The working channel number used by a system cannot be duplicate with that used by a
device of the same type.
3.3 Basic Operation
3.3.1 Charge the Transducer
Place the transducer in the docking slot and it displays the charging state on the transducer
screen.
NOTE:
When the TOCO-E transducer is connected with the DECG or MECG cable, it
cannot be charged due to poor contact with the charging points. Please remove the
DECG or MECG cable before charging.
Caution
Please wait for 2 minutes to use the transducers after charging.
3.3.2 Charge the Battery
Please pay attention to the battery level during monitoring process. The battery symbol displays
in the top right corner of the transducer screen. The low battery level may influence the
monitoring.
: It is fully charged.
: It is less fully charged.
: It is in low level. Please charge the battery. There is alarm information on the screen.
: It is out of power. Please charge the battery immediately.
Caution
1 When in indicates the power is low, please change for a new battery or charge the
rechargeable battery in time, or the monitoring will be interrupted.
2 After docking the transducer into the docking slot for charging, please check if the
transducer is well placed and whether it is charging.
To Next Page
Loading...
Need help?
General
