F9, F9 Express Fetal & Maternal Monitor User Manual Printing
- 68 -
4 Select OK.
5.2.4 Switching Print Self-Check On or Off
You can choose to switch print self-check on or off:
1 Select the setup key on the main interface.
2 Select Recorder > Print Self-Check.
3 Select ON (default) or OFF.
4 Select OK.
5.2.5 Changing Printing End Volume
The monitor gives a tone when printing ends and this tone volume is adjustable.
1 Select the setup key on the main interface.
2 Select Recorder > Print Ending Beep.
3 Select High, Low (default) or OFF.
4 Select OK.
5.2.6 Changing Title Print Cycle
1 Select the setup key on the main interface.
2 Select Recorder > Title Print Cycle.
3 Select 10min (Default), 20min, 30min, 60min.
4 Select OK.
5.2.7 Switching Maternal Monitor Information On or Off
1 Select the setup key on the main interface.
2 Select Recorder > Maternal Monitor Information.
3 Select ON (default) or OFF.
4 Select OK.
Note:
When the Maternal Monitor Information switch is turned off, the HR trace, SpO2
trace switch will be turned on automatically. You can turn them off manually if
needed.