Configuring the Switch
3-8
3
QoS 14-1
DiffServ Configure QoS classification criteria and service policies 14-1
Class Map Creates a class map for a type of traffic 14-2
Policy Map Creates a policy map for multiple interfaces 14-5
Service Policy Applies a policy map defined to an ingress port 14-8
IGMP Snooping 15-2
IGMP Configuration Enables multicast filtering; configures parameters for multicast
query
15-3
Multicast Router
Port Information
Displays the ports that are attached to a neighboring multicast
router for each VLAN ID
15-5
Static Multicast Router
Port Configuration
Assigns ports that are attached to a neighboring multicast router 15-6
IP Multicast Registration
Table
Displays all multicast groups active on this switch, including
multicast IP addresses and VLAN ID
15-7
IGMP Member Port Table Indicates multicast addresses associated with the selected
VLAN
15-7
MVR 15-9
Configuration Globally enables MVR, sets the MVR VLAN, adds multicast
stream addresses
15-10
Port Information Displays MVR interface type, MVR operational and activity
status, and immediate leave status
15-11
Trunk Information Displays MVR interface type, MVR operational and activity
status, and immediate leave status
15-11
Group IP Information Displays the ports attached to an MVR multicast stream 15-14
Port Configuration Configures MVR interface type and immediate leave status 15-8
Trunk Configuration Configures MVR interface type and immediate leave status 15-8
Group Member Configuration Statically assigns MVR multicast streams to an interface 15-15
DNS 16-1
General Configuration Enables DNS; configures domain name and domain list; and
specifies IP address of name servers for dynamic lookup
16-1
Static Host Table Configures static entries for domain name to address mapping 16-3
Cache Displays cache entries discovered by designated name servers 16-5
Table 3-2 Switch Main Menu (Continued)
Menu Description Page
To Next Page
Loading...
