Multicast VLAN Registration
15-11
15
CLI – This example first enables IGMP snooping, enables MVR globally, and then
configures a range of MVR group addresses.
Displaying MVR Interface Status
You can display information about the interfaces attached to the MVR VLAN.
Field Attributes
• Type – Shows the MVR port type.
• Oper Status – Shows the link status.
• MVR Status – Shows the MVR status. MVR status for source ports is “ACTIVE” if
MVR is globally enabled on the switch. MVR status for receiver ports is “ACTIVE”
only if there are subscribers receiving multicast traffic from one of the MVR groups,
or a multicast group has been statically assigned to an interface.
• Immediate Leave – Shows if immediate leave is enabled or disabled.
• Trunk Member
27
– Shows if port is a trunk member.
Web – Click MVR, Port Information or Trunk Information.
Figure 15-7 MVR Port Information
CLI – This example shows information about interfaces attached to the MVR VLAN.
Console(config)#ip igmp snooping 33-2
Console(config)#mvr 33-12
Console(config)#mvr group 228.1.23.1 10
Console(config)#
27. Port Information only.
Console#show mvr interface 33-14
Port Type Status Immediate Leave
------- -------- ------------- ---------------
eth1/1 SOURCE ACTIVE/UP Disable
eth1/2 RECEIVER ACTIVE/UP Disable
Console#
To Next Page
Loading...
Need help?
General