Web Server Commands
21-11
21
show tacacs-server
This command displays the current settings for the TACACS+ server.
Default Setting
None
Command Mode
Privileged Exec
Example
Web Server Commands
This section describes commands used to configure web browser management
access to the switch.
ip http port
This command specifies the TCP port number used by the web browser interface.
Use the no form to use the default port.
Syntax
ip http port port-number
no ip http port
port-number - The TCP port to be used by the browser interface.
(Range: 1-65535)
Default Setting
80
Command Mode
Global Configuration
Console#show tacacs-server
Remote TACACS server configuration:
Server IP address: 10.11.12.13
Communication key with TACACS server: *****
Server port number: 49
Console#
Table 21-7 Web Server Commands
Command Function Mode Page
ip http port Specifies the port to be used by the web browser interface GC 21-11
ip http server Allows the switch to be monitored or configured from a browser GC 21-12
ip http secure-server Enables HTTPS (HTTP/SSL) for encrypted communications GC 21-12
ip http secure-port Specifies the UDP port number for HTTPS GC 21-13
To Next Page
Loading...
Need help?
General