Configuring SNMPv3 Management Access
5-15
5
Web – Click SNMP, SNMPv3, Groups. Click New to configure a new group. In the
New Group page, define a name, assign a security model and level, and then select
read, write, and notify views. Click Add to save the new group and return to the
Groups list. To delete a group, check the box next to the group name, then click
Delete.
Figure 5-8 Configuring SNMPv3 Groups
swThermalFalling
Notification
1.3.6.1.4.1.259.8.2.2.2.1.0.59 This trap is sent when the temperature falls below
the switchThermalActionFallingThreshold.
swModuleInsertion
Notificaiton
1.3.6.1.4.1.259.8.2.2.2.1.0.60 This trap is sent when a module is inserted.
swModuleRemoval
Notificaiton
1.3.6.1.4.1.259.8.2.2.2.1.0.61 This trap is sent when a module is removed.
* These are legacy notifications and therefore must be enabled in conjunction with the corresponding traps on the
SNMP Configuration menu (page 5-6).
†The MIB OID for ES3528 is 1.3.6.1.4.1.259.8.2.2, and for ES3528-WDM is 1.3.6.1.4.1.259.8.2.3.
Table 5-2 Supported Notification Messages (Continued)
Object Label Object ID Description
To Next Page
Loading...
