System Management Commands
19-16
19
Command Usage
• If the file type is used for system startup, then this file cannot be deleted.
• “Factory_Default_Config.cfg” cannot be deleted.
Example
This example shows how to delete the test2.cfg configuration file from flash memory.
Related Commands
dir (19-16)
delete public-key (21-20)
dir
This command displays a list of files in flash memory.
Syntax
dir {{boot-rom: | config: | opcode:} [filename]}
The type of file or image to display includes:
• boot-rom
- Boot ROM (or diagnostic) image file.
• config - Switch configuration file.
• opcode - Run-time operation code image file.
• filename - Name of configuration file or code image. If this file exists but
contains errors, information on this file cannot be shown.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• If you enter the command dir without any parameters, the system displays all
files.
• File information is shown below:
Console#delete test2.cfg
Console#
Table 19-7 File Directory Information
Column Heading Description
file name The name of the file.
file type File types: Boot-Rom, Operation Code, and Config file.
startup Shows if this file is used when the system is started.
size The length of the file in bytes.
To Next Page
Loading...
Need help?
General