VLAN Commands
30-6
30
Editing VLAN Groups
vlan database
This command enters VLAN database mode. All commands in this mode will take
effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Use the VLAN database command mode to add, change, and delete VLANs.
After finishing configuration changes, you can display the VLAN settings by
entering the show vlan command.
•Use the interface vlan command mode to define the port membership mode
and add or remove ports from a VLAN. The results of these commands are
written to the running-configuration file, and you can display this file by
entering the show running-config command.
Example
Related Commands
show vlan (30-13)
Table 30-3 Commands for Editing VLAN Groups
Command Function Mode Page
vlan database Enters VLAN database mode to add, change, and delete
VLANs
GC 30-6
vlan Configures a VLAN, including VID, name and state VC 30-7
Console(config)#vlan database
Console(config-vlan)#
To Next Page
Loading...
Need help?
General