Time Commands
19-41
19
Command Usage
This command sets the local time zone relative to the Coordinated Universal
Time (UTC, formerly Greenwich Mean Time or GMT), based on the earth’s
prime meridian, zero degrees longitude. To display a time corresponding to
your local time, you must indicate the number of hours and minutes your time
zone is east (before) or west (after) of UTC.
Example
Related Commands
show sntp (19-40)
calendar set
This command sets the system clock. It may be used if there is no time server on
your network, or if you have not configured the switch to receive signals from a time
server.
Syntax
calendar set hour min sec {day month year | month day year}
• hour - Hour in 24-hour format. (Range: 0 - 23)
• min - Minute. (Range: 0 - 59)
• sec - Second. (Range: 0 - 59)
• day - Day of month. (Range: 1 - 31)
• month - january | february | march | april | may | june | july | august |
september | october | november | december
• year - Year (4-digit). (Range: 2001 - 2100)
Default Setting
None
Command Mode
Privileged Exec
Example
This example shows how to set the system clock to 15:12:34, February 1st, 2002.
Console(config)#clock timezone Japan hours 8 minute 0 after-UTC
Console(config)#
Console#calendar set 15:12:34 1 February 2002
Console#
To Next Page
Loading...
Need help?
General