Configuring Private VLANs
30-15
30
• Entering the pvlan command without any parameters enables the private
VLAN. Entering no pvlan disables the private VLAN.
Example
This example enables the private VLAN, and then sets port 12 as the uplink and
ports 5-8 as the downlinks.
show pvlan
This command displays the configured private VLAN.
Command Mode
Privileged Exec
Example
Console(config)#pvlan
Console(config)#pvlan up-link ethernet 1/12 down-link ethernet 1/5-8
Console(config)#
Console#show pvlan
Private VLAN status: Enabled
Up-link port:
Ethernet 1/12
Down-link port:
Ethernet 1/5
Ethernet 1/6
Ethernet 1/7
Ethernet 1/8
Console#
To Next Page
Loading...
Need help?
General