User Authentication Commands
21-18
21
Example
Related Commands
ip ssh crypto host-key generate (21-20)
show ssh (21-22)
ip ssh timeout
This command configures the timeout for the SSH server. Use the no form to restore
the default setting.
Syntax
ip ssh timeout seconds
no ip ssh timeout
seconds – The timeout for client response during SSH negotiation.
(Range: 1-120)
Default Setting
10 seconds
Command Mode
Global Configuration
Command Usage
The timeout specifies the interval the switch will wait for a response from the
client during the SSH negotiation phase. Once an SSH session has been
established, the timeout for user input is controlled by the exec-timeout
command for vty sessions.
Example
Related Commands
exec-timeout (19-22)
show ip ssh (21-22)
Console#ip ssh crypto host-key generate dsa
Console#configure
Console(config)#ip ssh server
Console(config)#
Console(config)#ip ssh timeout 60
Console(config)#
To Next Page
Loading...
Need help?
General