User Authentication Commands
21-28
21
Command Usage
• The re-authentication process verifies the connected client’s user ID and
password on the RADIUS server. During re-authentication, the client remains
connected the network and the process is handled transparently by the dot1x
client software. Only if re-authentication fails is the port blocked.
• The connected client is re-authenticated after the interval specified by the
dot1x timeout re-authperiod command. The default is 3600 seconds.
Example
Related Commands
dot1x timeout re-authperiod (21-28)
dot1x timeout quiet-period
This command sets the time that a switch port waits after the Max Request Count
has been exceeded before attempting to acquire a new client. Use the no form to
reset the default.
Syntax
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
seconds - The number of seconds. (Range: 1-65535)
Default
60 seconds
Command Mode
Interface Configuration
Example
dot1x timeout re-authperiod
This command sets the time period after which a connected client must be
re-authenticated. Use the no form of this command to reset the default.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
seconds - The number of seconds. (Range: 1-65535)
Console(config)#interface eth 1/2
Console(config-if)#dot1x re-authentication
Console(config-if)#
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#
To Next Page
Loading...
