Edge-Core ES3528-WDM User Manual

VLAN Commands
30-8
30
Configuring VLAN Interfaces
interface vlan
This command enters interface configuration mode for VLANs, which is used to
configure VLAN parameters for a physical interface.
Syntax
interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4093, no leading zeroes)
Default Setting
None
Command Mode
Global Configuration
Example
The following example shows how to set the interface configuration mode to
VLAN 1, and then assign an IP address to the VLAN:
Related Commands
shutdown (24-6)
Table 30-4 Commands for Configuring VLAN Interfaces
Command Function Mode Page
interface vlan Enters interface configuration mode for a specified VLAN IC 30-8
switchport mode Configures VLAN membership mode for an interface IC 30-9
switchport
acceptable-frame-types
Configures frame types to be accepted by an interface IC 30-9
switchport ingress-filtering Enables ingress filtering on an interface IC 30-10
switchport native vlan Configures the PVID (native VLAN) of an interface IC 30-11
switchport allowed vlan Configures the VLANs associated with an interface IC 30-11
switchport gvrp Enables GVRP for an interface IC 30-3
switchport forbidden vlan Configures forbidden VLANs for an interface IC 30-12
switchport priority default Sets a port priority for incoming untagged frames IC 31-3
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#

Edge-Core ES3528-WDM Specifications

General

Brand	Edge-Core
Model	ES3528-WDM
Category	Switch
Language	English

Summary

Chapter 1: Introduction

Key Features

Lists the switch's key features, including configuration backup, authentication, and port security.

System Defaults

Details the default configurations for console, authentication, web management, and SNMP.

Chapter 2: Initial Configuration

Connecting to the Switch

Explains how to connect to the switch via console port or Telnet for management.

Basic Configuration

Covers initial CLI access, setting passwords, and configuring IP addresses.

Chapter 3: Configuring the Switch

Using the Web Interface

Describes accessing the switch's web agent for configuration and monitoring network activity.

Main Menu

Provides a description of the selections available in the switch's web agent main menu.

Chapter 4: Basic Management Tasks

Displaying System Information

Explains how to view system name, object ID, location, contact, and hardware/software versions.

Setting the Switch’s IP Address

Guides on configuring IP interface for management access, including manual and dynamic methods.