EasyManuals Logo

Edge-Core ES3528-WDM User Manual

Edge-Core ES3528-WDM
556 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #361 background imageLoading...
Page #361 background image
802.1X Port Authentication
21-25
21
dot1x system-auth-control
This command enables IEEE 802.1X port authentication globally on the switch.
Use the no form to restore the default.
Syntax
[no] dot1x system-auth-control
Default Setting
Disabled
Command Mode
Global Configuration
Example
dot1x default
This command sets all configurable dot1x global and port settings to their default
values.
Command Mode
Global Configuration
Example
dot1x max-req
This command sets the maximum number of times the switch port will retransmit an
EAP request/identity packet to the client before it times out the authentication
session. Use the no form to restore the default.
Syntax
dot1x max-req count
no dot1x max-req
count – The maximum number of requests (Range: 1-10)
Default
2
Command Mode
Interface Configuration
Example
Console(config)#dot1x system-auth-control
Console(config)#
Console(config)#dot1x default
Console(config)#
Console(config)#interface eth 1/2
Console(config-if)#dot1x max-req 2
Console(config-if)#

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ES3528-WDM and is the answer not in the manual?

Edge-Core ES3528-WDM Specifications

General IconGeneral
BrandEdge-Core
ModelES3528-WDM
CategorySwitch
LanguageEnglish

Related product manuals