Account track: Account password
Specify the Account password for a job (up to 64 alphanumeric characters).
Note: To use this option, you must configure Account track on the printer.
Destination: Box number
Specify a Box number when using the Copier stored print option.
The Fiery ES sends the print job to the hard disk drive on the printer specified by the Box number.
The Box number is available from 1 to 999999999.
Note: If you specify the reserved number as 0, the printer cancels the job.
For more information, see the documentation that accompanies your printer.
Destination: Copier stored print
The Copier stored print option allows you to store a print job on the hard disk drive of the printer.
Do one of the following:
•
Select Off to send the image data as a normal print job.
•
Select HDD stored to store the print job on the hard disk drive of the printer.
•
Select HDD stored and print to store the print job on the hard disk drive of the printer and to print the job.
The hard disk drive (HDD) must be installed in the printer to select one of the HDD options.
For more information, see the documentation that accompanies your printer.
Job notes: Instructions
The Instructions print option allows you to specify instructions for the operator about the job.
This field accepts alphanumeric and special characters but does have a maximum limit.
Job notes: Notes 1/Notes 2
The Notes print option allows you to specify information about the job.
This field accepts alphanumeric and special characters but does have a maximum limit.
Note: If you enter < or = as the first character, the characters may not be printed in the Job Log, or the application in
use may shut down.
Job notes: Secure print
The Secure print print option should be used to print sensitive or confidential documents.
Specify an arbitrary password and re-enter it when you are present at the printer.
Printing
Print Options
65
To Next Page
