Eldes ESIM264 - Page 101

MANUAL ELDES ESIM264 V2.0 101
SMS
SMS text:
XXXX_REP:yyyyyyyy<zzzzzzzz
Value: yyyyyyyy – 8-digit old wireless device ID number; zzzzzzzz – 8-digit new
device ID number.
Example: 1111_REP:535185D<41286652
EKB2
N/A
EKB3
N/A
Both old and new device ID numbers are necessary in order to replace the wireless device.
After successful replacement the conguration of the old wireless device is automatically
applied to new device.
Replace Wireless
Device
SMS
SMS text:
XXXX_DEL:yyyyyyyy
Value: yyyyyyyy – 8-digit wireless device ID
number. Example: 1111_DEL:535185D
EKB2
N/A
EKB3
N/A
The wireless device ID is necessary in order to remove the device from the system.
This command allows to retrieve the following information of a particular wireless device: wi-
reless device battery level, wireless signal level, error rate (number of failed data transmission
attempts in 10-minute period) and rmware version.
Remove Wireless
Device
Wireless Device Info
ATTENTION: In order to fully
remove the device from the sys-
tem, please, restore the parame-
ters of ELDES wireless device to
default AND remove it from the
system. If the wireless device pa-
rameters are only reset to default
or the device is only removed
from the system, the wireless
device (except EWK1) and the
system attempts to exchange
data packets every 10 seconds
(attempts to keep wireless con-
nection alive). This leads to faster
battery discharge of battery-po-
wered ELDES wireless devices.
SMS
SMS text:
XXXX_RFINFO:Zn
Value: Zn - zone number of wireless device; yyyyyyyy - 8-digit wireless device ID
Example: 1111_RFINFO:8D2586B0
EKB2
OK -> CONFIGURATION -> RF DEVICES -> [RF DEVICE MODEL] [ID] -> BATTERY
OK -> CONFIGURATION -> RF DEVICES -> [RF DEVICE MODEL] [ID] -> SIGNAL
OK -> CONFIGURATION -> RF DEVICES -> [RF DEVICE MODEL] [ID] -> ERROR RATE
OK -> CONFIGURATION -> RF DEVICES -> [RF DEVICE MODEL] [ID] -> RF VERSION
EKB3
N/A
XXXX_RFINFO:yyyyyyyy
or