MANUAL ELDES ESIM264 V2.0 55
5.4.11 Arm/Disarm Notications
SMS
N/A
EKB2
Menu path:
OK → CONFIGURATION → PRIMARY SET → CALL/SMS SET → USER →
USER [1... 5] → ARM/DISARM EVENT → DISABLE
EKB3
Enter parameter 75 & parameter status value:
[75zx0#]
Value: xx – user number, range – [1... 5]
SMS
N/A
EKB2
Menu path:
OK → CONFIGURATION → PRIMARY SET →
CALL/SMS SET → USER → USER [1... 5] → ARM/DISARM EVENT → ENABLE
EKB3
Enter parameter 75 & parameter status value:
[75xx1#]
Value: xx – user number, range – [1... 5]
SMS
SMS text:
XXXX_MASTER:ON
Example: 1111_MASTER:ON
EKB2
Menu path:
OK → CONFIGURATION →
PRIMARY SET → CALL/SMS SET → INF ABOUT ARM/DARM → ENABLE
EKB3
Enter parameter 22 & parameter status value:
[221#]
The system sends SMS message to User 1 after arming and disarming process (except - by
phone call). This function disables this SMS message for a specied user. By default, this fea-
ture is enabled for all users.
This command enables Arm/Disarm Event SMS message.
The system simultaneously sends SMS message to all users with Arm/Disarm SMS feature ena-
bled, after arming and disarming process (by any method). By default, this feature is disabled.
Disable Arm/
Disarm SMS
Enable Arm/
Disarm SMS
Enable Arm/Disarm
SMS to All Users
Simultaneously
NOTE: After arming or dis-
arming the alarm system by
phone call, the system sends
SMS message to user who
made a phone call only.
NOTE: By default, Arm/Disarm SMS is enabled for all users, but sent to User 1 only. However Users 2 - 5 can receive this SMS message as
well after Arm/Disarm SMS to All Users Simultaneously is enabled.
To Next Page
Loading...
