Eldes ESIM264 - Notification about Temperature Change

56
5.4.12 Temperature Change Notications
SMS
SMS text:
XXXX_TEMP:0:0
Example: 1111_TEMP:0:0
EKB2
Menu path:
OK → CONFIGURATION → PRIMARY SET → TEMP SENSOR → INFO SMS → DISABLE
EKB3
Enter parameter 50 & parameter status value:
[500#]
SMS
SMS text:
XXXX_MASTER:OFF
Example: 1111_MASTER:OFF
EKB2
Menu path:
OK → CONFIGURATION → PRIMARY SET →
CALL/SMS SET → INF ABOUT ARM/DARM → DISABLE
EKB3
Enter parameter 22 & parameter status value:
[220#]
Temperature Limit Info SMS is sent to all preset users when temperature exceeds the min. or
max. set temperature value. By default, this SMS message is enabled
The temperature is measured by temperature sensor connected to ESIM264 alarm system.
This command disables Arm/Disarm SMS to All Users Simultaneously.
Disable Temperature
Limit Info SMS
Disable Arm/Disarm
SMS to All Users
Simultaneously
NOTE: Despite the status of Temperature Limit Info SMS, the temperature is always indicated in Info SMS content and displayed in EKB2
main screen view.