Eldes ESIM264 - Remote System Configuration via GPRS

MANUAL ELDES ESIM264 V2.0 23
EKB3
The system conguration and control with EKB3 keyboard is performed by activating the Conguration Mode using the
administrator password (the default administrator password is 1470) and entering a valid conguration command using
the number keys (0... 9) and [#] key for conrmation. The indication of each pressed key is provided by zone red LEDs
when entering a conguration command. The structure of standard conguration command is a combination of digits.
EKB3 conguration command and valid parameter value range are indicated in brackets.
EKB3 indications which are relevant during Conguration Mode are described in the table below.
Indication Description
Red LED ARMED ashing Conguration mode activated successfully.
Yellow LED SYSTEM ashing Valid parameter is entered and waiting for value.
1 Long Beep Non-existing command or parameter value entered.
3 Short Beeps Command entered successfully.
NOTE: The system can be congured using one keyboard at a time only. Other connected keyboards become inactive in Con-
guration Mode.
Software ELDES Conguration Tool is intended to work directly with ESIM264 alarm system, which can be connected to
the computer via USB port or via GPRS connection remotely. This software simplies system conguration process by al-
lowing to use a personal computer in the process. Before starting to use ELDES Conguration Tool, please, read user guide
available in the software’s HELP section.
ELDES Conguration Tool is freeware and can be downloaded from ELDES website at: www.eldes.lt
This command activates and deactivates the Conguration Mode.
Conguration
Mode
Enter administrator password:
[*xxxx#]
Value: xxxx – 4-digit adiministrator password.
CONFIGU
RATION
TOOL
5.3 Remote System Conguration via GPRS Connection
Before conguring ESIM264 remotely via GPRS connection, make sure that:
• SIM card is inserted into ESIM264 device.
• Mobile internet service is enabled on the SIM card.
• Power supply is connected to ESIM264.
• Default SMS password is changed to a new 4-digit password;
• At least User1 phone number is set up.
EKB3