Eldes ESIM264 - Monitoring Station Parameter Configuration

MANUAL ELDES ESIM264 V2.0 117
* - does not contain specic alarm type indication.
** - does not contain password type Stay mode indication.
*** - contains violated tamper number with a star “*” character.
9.3 Monitoring Station Parameter Conguration (SMS, EKB2, EKB3)
9.3.1 Main Parameters
SMS
SMS text:
XXXX_scnset:on
EKB2
Menu path:
OK → CONFIGURATION → ARC SET → CONTACT ID MSG → CID ENABLED → ENABLE
EKB3
Enter parameter 23 & parameter status value:
[231#]
SMS
SMS text:
XXXX_scnset:o
EKB2
Menu path:
OK → CONFIGURATION → ARC SET → CONTACT ID MSG → CID ENABLED → DISABLE
EKB3
Enter parameter 23 & parameter status value:
[230#]
This mode enables data transmission from alarm system ESIM264 to the monitoring station.
By default, this mode is disabled.
This command disables CID mode.
Enable CID mode
Disable CID mode