Endress+Hauser Proline Prowirl R 200 - Page 87

Proline Prowirl R 200 HART Commissioning
Endress+Hauser 87
Parameter Prerequisite Description Selection / User
entry
Factory setting
Failure mode In the Operating mode
parameter, the Pulse option is
selected, and one of the
following options is selected in
the Assign pulse output
parameter (→  86):
• Volume flow
• Corrected volume flow
• Mass flow
• Total mass flow
*
• Energy flow
*
• Heat flow difference
*
Define output behavior in
alarm condition.
• Actual value
• No pulses
No pulses
Invert output signal – Invert the output signal. • No
• Yes
No
* Visibility depends on order options or device settings
Configuring the frequency output
Navigation
"Setup" menu → Pulse/frequency/switch output
Pulse/frequency/switch output
Assign frequency output
→  88
Minimum frequency value
→  88
Maximum frequency value
→  88
Measuring value at minimum
frequency
→  89
Measuring value at maximum
frequency
→  89
Failure mode
→  89
Failure frequency
→  90
Invert output signal
→  90