Using the PostScript Printer Driver 199
6
6
6
6
6
6
6
6
6
6
6
6
1. Make sure that the printer is turned off. Insert the printer
software CD-ROM into your CD-ROM drive.
2. Connect your computer to the printer with a USB cable, then
turn on the printer.
3. Install the USB Device Driver.
For Windows Me, select Automatic search for a better
driver (Recommended), click Next, then go to step 6.
For Windows 98, click Next in the Add New Hardware
Wizard. Select Search for best driver for your device
(Recommended), then click Next.
Note:
For Windows XP or 2000, a USB Device Driver is installed
automatically. Go to step 7.
4. Select Specify a location, then specify the following path for
the CD-ROM. If your CD-ROM drive is D:, the path will be
D:\ADOBEPS\ENGLISH\WIN9X\PS_SETUP Then click
Next.
Note:
Change the drive letter as needed for your system.
5. Click Next to continue.
6. When installation of the USB Device Driver is done, click
Finish.
Operating system version Folder Name
Windows Me or 98 WIN9X
Windows XP or 2000 WIN2K_XP
To Next Page
Loading...
Need help?
General