Epson AcuLaser C4200DN User Manual

Troubleshooting 385
11
11
11
11
11
11
11
11
11
11
11
11
Half-tone images print unevenly
New :For color product
Toner smudges
New :vary according to product (eg. photoconductor unit) /delete unnecessary information
There may be no toner left in the
toner cartridge.
If the message on the LCD panel or in
EPSON Status Monitor indicates that the
amount of toner left is low, see"Toner
Cartridge" on page 312.
You can also check the remaining toner
with the following symbols on the Basic
Settings tab in the printer driver.
Toner low: !
Toner end: ×
There may be a problem with the
photoconductor unit.
Replace the photoconductor unit. See
"Photoconductor Unit" on page 318.
Cause What to do
Your paper may be moist or damp. Do not store paper in a humid or damp
environment. Be sure to use paper that is
newly unwrapped.
There may be no toner left in the
toner cartridge.
If the message on the LCD panel or in
EPSON Status Monitor indicates that the
amount of toner is low, replace the toner
cartridge. See "Toner Cartridge" on page
312.
You can also check the remaining toner
with the following symbols on the Basic
Settings tab in the printer driver.
Toner low: !
Toner end: ×
The gradation setting is too small
when printing graphics.
On the Basic Setting menu in the printer
driver, click More Settings, select the
Enh.MG button, then select Smooth.
There may be a problem with the
photoconductor unit.
Replace the photoconductor unit. See
"Photoconductor Unit" on page 318.

Epson AcuLaser C4200DN Specifications

General

Brand	Epson
Model	AcuLaser C4200DN
Category	Printer
Language	English