Replacing Consumable Products 319
9
9
9
9
9
9
9
9
9
9
9
9
Always observe the following handling precautions when
replacing the consumable products:
❏ The photoconductor unit weighs 3.2 kg (7.1 lb). Be sure to hold
it firmly by the handle when carrying it.
❏ When replacing the photoconductor unit, avoid exposing it
to room light any longer than necessary.
❏ Be careful not to scratch the surface of the drum (green roller)
and rollers (black rollers), Also, avoid touching the drum,
since oil from your skin may permanently damage its surface
and affect print quality.
❏ To get the best print quality, do not store the photoconductor
unit in an area subject to direct sunlight, dust, salty air, or
corrosive gases (such as ammonia). Avoid locations subject to
extreme or rapid changes in temperature or humidity.
❏ Do not tilt the photoconductor unit.
w
Warning:
❏ Do not dispose of the used consumable products in fire,
as it may explode and cause injury. Dispose of it
according to local regulations.
❏ Keep the consumable products out of the reach of
children.
Replacing the photoconductor unit
Follow the steps below to replace the photoconductor unit.
1. Turn off the printer.
To Next Page
Loading...
Need help?
General