Using the Control Panel 245
7
7
7
7
7
7
7
7
7
7
7
7
If you select Off, the printer does not send an automatic line-feed
(LF) command with each carriage-return (CR). If On is selected, a
line-feed command is sent with each carriage-return. Select On if
your text lines overlap.
Bit Image
The printer is able to emulate the graphics densities set with the
printer commands. If you select Dark, the bit image density is
high, and if you select Light, the bit image density is low.
If you select BarCode, the printer converts bit images to bar codes
by automatically filling in any vertical gaps between dots. This
produces unbroken vertical lines that can be read by a bar code
reader. This mode will reduce the size of the image being printed,
and may also cause some distortion when printing bit image
graphics.
ZeroChar
Selects whether the printer prints a slashed or unslashed zero.
I239X Menu
New :Emulation only
The I239X mode emulates IBM
®
2390/2391 Plus commands.
These settings are available only when the printer is in the I239X
mode.
To Next Page
Loading...
Need help?
General