Using the Control Panel 239
7
7
7
7
7
7
7
7
7
7
7
7
Specifies the data format. Select On for the Binary data and select
Off for the ASCII data.
Note:
❏ Binary can only be used with network connection.
❏ You do not have to select On when using AppleTalk.
To use the Binary data, make sure your application supports
Binary data and that SEND CTRL-D Before Each Job and SEND
CTRL-D After Each Job are set to No.
When this setting is set to On, you cannot use TBCP (Tagged binary
communication protocol) and Job Management in the printer
driver settings.
ESCP2 Menu
New :Emulation only
This menu allows you to make settings which affect the printer
when it is in the ESC/P 2 emulation mode.
To Next Page
Loading...
