310 Installing Options
12. Turn on the printer.
To confirm that the option is installed correctly, print a Status
Sheet. See "Printing a Status Sheet" on page 377.
If P5C is not listed as an installed emulation on the status sheet,
try reinstalling the module. Make sure that it is securely seated
into the ROM slot on the circuit board.
Removing the P5C ROM module
c
Caution:
Before you remove the ROM module, be sure to discharge any
static electricity by touching a grounded piece of metal.
Otherwise, you may damage static-sensitive components.
w
Warning:
Be careful when working inside the printer as some components
are sharp and may cause injury.
Perform the installation procedure in revers.
To Next Page
Loading...
