Using the Control Panel 235
7
7
7
7
7
7
7
7
7
7
7
7
USB SPEED
Allows you to select the operation mode of USB interface.
Selecting HS is recommended. Select FS if HS does not work on
your computer system.
Buffer Size
Determines the amount of memory to be used for receiving data
and printing data. If Maximum is selected, more memory is
allocated for receiving data. If set to Minimum is selected, more
memory is allocated for printing data.
Note:
❏ To activate Buffer Size settings, you must turn off the printer for
more than five seconds then turn it back on. Or, you can perform a
Reset All operation, as explained in "Reset Menu" on page 230.
❏ Resetting the printer erases all print jobs. Make sure the Ready
light is not flashing when you reset the printer.
Network Menu
New :Network standard only
See the Network Guide for each setting.
AUX Menu
New :Network standard only
See the Network Guide for each setting.
P5C Menu
These settings are available in the P5C mode.
To Next Page
Loading...
Need help?
General