Using the PostScript Printer Driver 201
6
6
6
6
6
6
6
6
6
6
6
6
5. Select the Create a new port check box and select
Standard TCP/IP Port from the drop-down list. Click Next.
6. Click Next to continue.
7. Specify the IP address and port name, then click Next.
8. Click Finish.
9. Click Have Disk in the Add Printer Wizard and specify the
following path for the CD-ROM. If your CD-ROM drive is D:,
the path will be
D:\ADOBEPS\ENGLISH\WIN2K_XP\PS_SETUP. Then click
OK.
Note:
Change the drive letter as needed for your system.
10. Select the printer and click Next.
11. Follow the on-screen instructions for the rest of the
installation.
12. When installation is done, click Finish.
For Windows Me or 98 users
1. Install the EpsonNet Print. Refer to “Installing EpsonNet
Print” in the Network Guide to find the instructions.
2. Install the printer driver. See "Installing the PostScript printer
driver for the parallel interface" on page 196 for details.
3. Set the printer port to EpsonNet Print Port. Refer to
“Configuring the Printer Port” in the Network Guide to find
the instructions.
Note:
High-speed Printing (RAW) is not supported.
To Next Page
Loading...
