Using the Control Panel 251
7
7
7
7
7
7
7
7
7
7
7
7
To clear this error, select Clear Warning from the control panel’s
Reset Menu. For instruction about accessing the control panel
menus, see "How to access the control panel menus" on page 214.
Duplex Mem Overflow
There is not enough memory for duplex printing. The printer
prints only on the front and ejects the paper. To clear this error,
follow the instructions below.
If Off is selected as the Auto Cont setting on the control panel’s
Setup Menu, press the N Start/Stop button to print on the back of
the next sheet, or press the + Cancel Job button to cancel the
print job.
If On is selected as the Auto Cont setting on the control panel’s
Setup Menu, printing continues automatically after a certain
period of time.
Face-down Full
The output paper at the face-down tray is full. Remove the paper
that has been output, then press the N Start/Stop button. Printing
resumes.
Form Data Canceled
Unable to store form overlay data on the printer’s optional Hard
Disk Drive. Either the drive is full, or the maximum number of
form overlay files has been reached. Delete any form overlay files
you no longer need, then try storing the new overlay again.
To clear this error, select Clear Warning from the control panel’s
Reset Menu. For instruction about accessing the control panel
menus, see "How to access the control panel menus" on page 214.
Form Feed
To Next Page
Loading...
Need help?
General