221
Appendix
Roll paper Continuous Label (Black Mark)
Form Roll paper
Backing paper width 25.4 to 215.9 mm
Label width With waste part: 25.4 to 215.9 mm
Without waste part: 21.4 to 211.9 mm
Label length -
Gap between Labels -
Waste part on the left and right With waste part: -
Without waste part: 2 ± 0.5 mm
Label corner R -
Paper thickness Matte Paper: 0.178 mm
Synthetic: 0.229 mm
Glossy Paper: 0.174 mm
Glossy Film: 0.164mm
High Glossy Paper: 0.188mm
Roll paper core inner diameter 76.2 mm ± 0.5 mm
Roll paper outer diameter 152.4 mm or less
Winding direction Print side must be facing outside (facing inside is unusable)
Black mark position 18.4 mm or more away from the side edge baseline
<Reverse Side>
<Print Side>
Waste part
Waste part
Backing paper
Label area
Black mark length
Side edge
baseline
Center of black
mark detector
Black mark width
Backing paper width
Paper feed direction
Gap between pages
Label width
Center of black
mark detector
Side edge
baseline
Cut position
To Next Page
Loading...
Need help?
General
