Epson ColorWorks CW-C6500 Series - Page 84

84
Chapter3 Handling
How to Specify Barcode Data
See the following descriptions to specify barcode data.
About the composite symbol:
Switching between CC-A and CC-B is automatically performed, however, to use CC-C, you need to specify to
use it.
(For GS1-128, the type of composite component can be selected from [No composite], [CC-A/CC-B], and [CC-
C].)
About HRI characters:
If the length of the HRI characters becomes wider than entire width of the barcode, the length is regarded
as the barcode width.
UPC-A
• Specify the barcode data with 11 digits. A check digit will be automatically added.
UPC-E
• Specify the barcode data with 10 digits. 5 digits are for a manufacturer code, and the rest of 5 digits are for a
product code.
JAN13(EAN)
• Specify the barcode data with 12 digits. A check digit will be automatically added.
JAN8(EAN)
• Specify the barcode data with 7 digits. A check digit will be automatically added.
Code39
• If both or either one of a start code or a stop code is not specified, they will be automatically added.
ITF
• If specified with an odd number of digits, “0” (zero) will be automatically added at the beginning of the dig-
its.
Codabar(NW7)
• Do not include a start code and a stop code. The start code and stop code you specified on the printer driver
will be added.
Composite component type Encodable number of digits
CC-A 1 to 56 digits
CC-B 1 to 338 digits
CC-C 1 to 2361 digits