Epson Stylus Pro 4400 - Page 195

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Troubleshooting Troubleshooting Based on Panel Messages 195
SERVICE REQ. 10000XXX
 Error meaning:
CPU error
 Cause of trouble
 Defective circuit board
 Faulty CPU soldering
 Program trouble
 Generation error
 Remedy
1. Installing Firmware (p.444)
2. Replace the C593 MAIN Board (p.226)
SERVICE REQ. 0003XXXX
SERVICE REQ. 0DXXXXXX
 Error meaning:
Error code for debug
 Cause of trouble
 Defective circuit board.
 Defective SDRAM.
 Defective Flash memory.
 Faulty ASIC soldering.
 Faulty CPU soldering.
 Program trouble
 Generation error.
 Remedy
1. Installing Firmware (p.444)
2. Replace the C593 MAIN Board (p.226)
SERVICE REQ. 0EXXXXXX
 Error meaning:
RTC timer off error
 Explanation
This error occurs when attempting unsuccessfully to communicate with
RTC chip on the MAIN Board.
0Exxyyzz :
xx: Compare error location
(00=LTMR1, 01=LTMR0, 02=MIN counter)
yy: Setting value (writing value)
zz: setting result (value read during comparing)
 Remedy
1. Turn the printer off and back on.
2. Turn on the printer in Maintenance Mode 2 (p.90), and execute
"RTC&USB ID&IEEE1394 ID” to set the date using basic adjustment
in adjustment program.