Epson Stylus Pro 4400 - Roller Assy., LD, Left; Roller Assy., LD, Right; Gear, 44.47 and Lever, Hopper, Release Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 254
4.2.6.2 Roller Assy., LD, Left / Roller Assy., LD, Right
1. Remove "ASF Unit" (p246).
2. Remove the "E-ring, 6", and pull out the "Gear, 44.74" and "Lever, Hopper,
Release" from the "Shaft, Roller, LD".
Figure 4-62. "Gear, 44.47" and "Lever, Hopper, Release" Removal
When installing the "Gear, 44.74" and "Lever, Hopper,
Release" to the "Shaft, Roller, LD", face the surfaces with the
longer ribs of both the "Gear, 44.74" and the "Lever, Hopper,
Release" toward the "ASF Unit" side, and match the
respective ribs of the shaft holes with the grooves of the
"Shaft, Roller, LD".
Lever, Hopper, Release
Gear, 44.47
E-ring, 6