Epson Stylus Pro 4400 - Extension Spring, 2.58 Removal; PG Phase Sensor Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 279
4. Remove "Extension Spring, 2.58" from the frame and the two tabs of the
"Installation Plate, Detector, HP". (Refer to Figure 4-97.)
5. Disconnect the connector from the "PG Phase Sensor".
(Refer to Figure 4-98.)
6. Release the tabs securing the "PG Phase Sensor" and remove the "PG
Phase Sensor". (Refer to Figure 4-98.)
Figure 4-97. Extension Spring, 2.58 Removal
Figure 4-98. PG Phase Sensor Removal
Extension Spring, 2.58
Installation Plate, Detector, HP
Tabs
Hooks
Connector