Epson Stylus Pro 4400 - Adjustment

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Product Description Operating Panel 80
 Adjustment
The adjustment values set above are saved in NVRAM as 4 types of
adjustment value depending on PG height (0.7mm/1.2mm/1.5mm/2.1mm/
2.6mm). To calculate adjustment value, PG height and paper thickness are
necessary. Saving place of adjustment value is selected as following list.
Adjustment value saved in NVRAM is updated when the value is adjusted
again.
Note *1: For the other PG settings (for 0.7/2.1/2.6), overwrite the values adding a
offset value if the set value in the user area and the default values are the
completely same with each other. If the PG setting differs in any one of eight
colors, do not overwrite the current settings because the difference means
that the user has changed the setting.
*2: Even when paper thickness sensor detects thin paper (less than 0.8mm), PG
is set as 2.6mm if paper thickness setting is more than 0.7mm.
*3: When paper thickness sensor detects thick paper (more than 0.8mm), PG is
set as 2.6mm regardless of PG setting and paper thickness setting.
Note 1: It is saved into saving place for paper thickness 0.0mm.
2: It is saved into saving place for paper thickness 0.3mm.
3: Paper thickness is saved to adjust paper thickness by 0.1mm unit for paper
thickness setting command PH.
4: Paper thickness is firstly entered to print the closest pattern print of adjustment
value saved in the printer from the first time and reduce operation.
Paper
thickness
sensor
Paper thickness
setting
PG setting Saving place Notes
Less than
0.8mm
STD
-- For PG 1.2mm *1
More than
0.8mm
-- For PG 2.6mm
Less than
0.3mm
0.1~0.8mm
Narrow For PG 0.7mm
Standard For PG 1.2mm
Wide For PG 1.5mm
Wider For PG 2.1mm
Widest For PG 2.6mm
0.9~1.5mm -- For PG 2.6mm *2
More than
0.3mm
Less than
0.8mm
0.1~0.8mm
Narrow For PG 1.2mm
Standard For PG 1.2mm
Wide For PG 1.5mm
Wider For PG 2.1mm
Widest For PG 2.6mm
0.9~1.5mm -- For PG 2.6mm *2
More
than0.8mm
0.0~1.5mm
-- For PG 2.6mm *3