Epson Stylus Pro 4400 - Directional View of the Printer; Required Tools; Tools

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Introductory Information 203
Figure 4-1. Directional View of the Printer
4.1.2 Tools
Tools needed for disassembly/reassembly of the Stylus Pro 4400/4450/4800/
4880/4880C are shown below.
Note "*": "xx" letters differ for each cartridge.
Rear (back side)
Right
Left
Top
Bottom
Front
Table 4-1. Required Tools
Name Part Code Note
(+) Phillips screwdriver #1 Commercial Tool –
(+) Phillips screwdriver #2 Commercial Tool Shaft length of 250mm
or more is preferred.
Flathead screwdriver Commercial Tool –
Needle nose pliers Commercial Tool –
Tweezers Commercial Tool –
Torque wrench 1.25/1.75 1277142 For coupling screws
Hex wrench Commercial Tool For roll paper feeder
Ink cartridge ICxx24* –
Maintenance Tank PXMT2 –
HEAD EXCHANGE SUPPORT
TOOL
1294672 Used in Print Head
replacement
CUTTER CAP 1401456 Used in Print Head
replacement
CR SUS PLATE SUPPORT TOOL 1400023 Used in Carriage Unit
and Print Head
replacement
ASF EXCHANGE SUPPORT TOOL 1401458 Used in ASF Unit
replacement