Epson Stylus Pro 4400 - Panel Setting; Outline

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Product Description Operating Panel 40
1.4.4 Panel Setting
1.4.4.1 Outline
 Startup
The printer mode is selected by pressing the [Menu / Cleaning] button
during print ready, warning, or maintenance call status. The printer is then
automatically incapable of printing.
 Operation
1. The Printer setting menu can be entered by pushing the [Menu /
Cleaning] button once during menu shift available state (Print ready,
no paper). It is shifted to setting menu select mode, and the setting
menu is displayed on the left side of the LCD upper line.
2. Each setting menu is displayed one after another by pushing [Paper
Feed] buttons in the setting menu select mode. It is shifted to setting
item select menu by pushing [Menu / Cleaning] button. "Setting menu"
is displayed on the upper line, and "Setting item" is displayed on the
lower line.
3. The setting menu is displayed one after another by pushing [Paper
Feed] buttons in the setting item select mode. It is shifted to setting
value select mode of the setting item by pushing [Menu / Cleaning]
button. "Setting item" is displayed on the upper line, and "Setting
value" is displayed on the lower line. The "*" displayed at left side of
the setting value represents the current setup value.
4. Setting value is displayed on the lower line one after another by
pushing [Paper Feed] buttons in the setting value select mode if the
setting value can be changed. The "*" at left side of the setting value
represents the current setup value.
5. When the [Menu / Cleaning] button is pushed at the setting value
select mode, the displayed setting value is entered and registered as
the current setting value. If it has a corresponded operation, execution
starts. No operation occurs if "*" is already displayed.
6. It returns to the setting item select menu by pushing [Select paper
type] button in the setting value select mode. It returns to the setting
menu select mode by pushing [Select paper type] button in the setting
item select menu.
 Termination
 The printer enters the menu shift available status when the [Pause]
button is pushed once in the Panel setting mode.
 The printer enters the menu shift available status when the [Select
paper type] button is pushed once in setting menu select mode.
 The printer enters the menu shift available status when executing
initialization.
 The printer enters the print ready status after the nozzle check pattern
or the status sheet is printed.
 The printer enters the menu shift available status after black ink is
replaced.
 The printer enters the menu shift available status after the cutter is
replaced.
 The printer returns to the menu shift available status when [Pause]
button is pressed in any modes.
NOTE: Under special condition, there are times when returning to the
above status is impossible.