Epson Stylus Pro 4400 - Writing Color ID (at Repair Work Site); Writing Colorimetric Calibration ID

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Adjustment Basic Adjustment 429
 Writing Color ID (at repair work site)
1. Start the adjustment program and select [Colorimetric Calibration ID].
2. Click [Run] to start “Colorimetric Calibration Tool”.
3. Click [Write Color ID].
4. Perform Step 5 to 6 of "Adjustment Procedure (Entire Process Workflow)"
to check the connection status to the printer.
5. Select [File] from “Input Method”.
6. Click [Specify the file], select the color ID data file (dat format), and click
[Next].
7. Make sure that the S/N shown in the input data is the same as that of the
connected printer and that it should be the same as the product number of
the printer. Click [Next].
8. When the writing is complete, click [End]
Figure 5-81. Writing Colorimetric Calibration ID