Epson Stylus Pro 4400 - Guide Rail Removal; Bracket Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 231
11. Release the four hooks securing the "Guide Rail" and remove the "Guide
Rail". (Refer to Figure 4-36.)
12. Remove the two screws securing the "Bracket" and remove the
"Bracket".(Refer to Figure 4-37.)
 C.B.S. 3x8: 2 pcs.
Figure 4-36. Guide Rail Removal
Figure 4-37. Bracket Removal
Secure the two "Guide Rail" hooks to the two "C593 MAIN
Board" installation holes.
Install while aligning the two "Bracket" dowels with the two
"C593 MAIN Board" positioning holes.
Hooks
Installation Holes
Dowels
Positioning Holes
1
2
3
Guide Rail
C.B.S 3x8
Bracket