Epson Stylus Pro 4400 - Holder, FFC; Holder, FFC Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 325
4.2.8.9 Holder, FFC
1. Move the "Carriadge Unit" depending on which "Holder, FFC" is removed
with reference to both Figure 4-166 and the table below.
2. Pinch the upper and lower end of the two "Harness, Head"s and the
"Harness, Head, Intermit" with your fingers to make their central parts
bowed, and release them from the upper and lower tabs of the "Holder,
FFC".
Figure 4-166. Holder, FFC
Figure 4-167. Holder, FFC Removal
"Holder, FFC" to be removed "Carriage Unit" position
A ~ B Home position
C ~ E Left end
C A U T I O N
To prevent the "Harness, Head"s and "Harness, Head,
Intermit" from being bent, bow the "Harness, Head"s and
"Harness, Head, Intermit" little by little.
E D
C
B
A
Tabs
Holder, FFC