Epson Stylus Pro 4400 - I;H Left Unit; I;H Lever Sensor (Left); Cover, I;H, Left Removal; I;C, Lock Lever, Knob, Left Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 296
4.2.8.4 I/H Left Unit / I/H Lever Sensor (Left)
1. Remove "Panel, Front/Panel Unit" (p219).
2. Open "Cover, I/H, Left".
3. Hold both ends of "Cover, I/H, Left" and disengage each side from the
hinge sockets. (Refer to Figure 4-122.)
4. Remove the screw securing the "I/C, Lock Lever, Knob, Left" and then
remove the "I/C, Lock Lever, Knob, Left".
(Refer to Figure 4-123.)
 C.B.P. 3x6: 1 pc.
Figure 4-122. Cover, I/H, Left Removal
Figure 4-123. I/C, Lock Lever, Knob, Left Removal
C A U T I O N
When performing the following work, remove ink out of the
the ink path before removing the "IH Left Unit". Refer to
Chapter 5 “Adjustment” (p.366) to know how to remove ink.
The "I/C, Lock Lever, Knob, Left" has upward and downward
directions. Install it in the correct direction.
Release Mark: Top
Set Mark: Bottom
Hinge Sockets
I/C, Lock Lever, Knob, Left
C.B.P. 3x6