Epson Stylus Pro 4400 - Cover, Printer; Plate, P Cover, Left Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 221
4.2.3.6 Cover, Printer
1. Remove "Cover, Side, Left" (p216).
2. Remove the two screws securing "Plate, P Cover, Left". Then remove
"Plate, P Cover, Left" by sliding it to the left side while supporting "Cover
Printer" with your hand.
 C.B.S. 3x6: 2 pcs.
Figure 4-23. Plate, P Cover, Left Removal
Follow the steps below when installing "Plate, P Cover,
Left".
1. Insert "Plate, P Cover, Left" into gap between "Cover,
Rear" and main frame.
2. Insert shaft socket hole of "Plate, P Cover, Left" to
"Cover, Printer" shaft (left).
3. Align "Plate, P Cover, Left" dowel with main frame
positioning hole.
4. Secure with the two screws.
• C.B.S. 3x6 : 2 pcs.
Shaft of Cover, Printer
Shaft Socket Hole
Positioning Hole
Cover, Rear
Dowel
Cover Printer
Plate, P Cover, Left
C.B.S 3x6