Epson Stylus Pro 4400 - Corrective Actions for Error Display

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Troubleshooting Troubleshooting Based on Panel Messages 165
3.2.3 Corrective Actions for Error Display
Error messages replace the "READY"/"PRINTING" message in the LCD to notify the user of the condition.
The following explains corrective actions for when the errors are displayed.
CLEANING FAILURE
CLEANING UNAVAILABLE
MULTI SENSOR SN GAIN ERROR
MULTI SENSOR PAPER RECOGNITION ERROR
CUT SHEET SIZE ERROR
LCD Explanation Recovery
NOZZLES STILL CLOGGED Dot missing is still detected even after the applicable number of auto
cleanings were performed as Multi Sensor had detected the dot
missing.
Compulsory return to Ready by pressing [Pause] key. (However, there
is still dot missing.)
LCD Explanation Recovery
REMOVE PAPER Paper with thickness greater than 0.9mm is set at power ON or
execution of cleaning.
Release Paper Lever, remove paper, and pull down the lever.
LCD Explanation Recovery
CHANGE PAPER TYPE Required amount of reflection not obtained after automatic adjustment
pattern print. (Generated with blurred paper.)
Release Paper Lever, reload the paper, and pull down the lever.
LCD Explanation Recovery
CHANGE PAPER TYPE Gain for Multi Sensor not obtained at 0.5V or more or 3V or less. Can
also be generated when there is no paper or low reflection paper is
used.
Release Paper Lever, reload the paper, and pull down the lever.
LCD Explanation Recovery
WRONG PAPER SIZE After paper width detection, set paper width and print data paper width
are different.
Correct by setting to designated paper size with the driver.
Resume printing by pressing the [Pause] key.
When resuming printing, printing will clip to paper width.
Stop printing by pressing and holding [Pause] key for 3 seconds.
(It will be necessary to delete the print job at the PC.)