EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Product Description Operating Panel 48
1.4.4.3  Remaining paper detection
This mode displays remaining counter of roll paper length / number of cut sheet 
which is set by a user, and can display a warning message when it reaches the 
near end setting value which is also set by the user.
However, remaining roll paper menu is displayed when remaining paper 
display setting is set to roll paper in Maintenance Mode, and remaining cut 
sheet menu is displayed when it is set to cut sheet. When remaining paper 
display setting is off, these menus do not appear.
NOTE: Remaining roll paper detection and remaining cut sheet detection cannot 
be set to ON simultaneously.
 Level structure of remaining roll paper menu
Note 1: Roll paper length can be set on 0.5m basis within 5.0 to 99.5m.In addition, the 
unit length can be changed on 10m basis by holding down the up/down key.The 
near end value can be set on 1m basis within 1 to15m.
2: If the unit length is changed in Maintenance Mode, all the value of roll paper 
length, near end, and remaining paper display are returned to the initial 
settings.
 Level structure of remaining cut sheet menu
Note : The number of cut sheet can be set on 10 sheets basis within 10 to 250 sheets.
The near end value can be set on 1 sheet basis within 5 to 50 sheets.
[∧ / ∨]
[< / >]
[>]
PRINTER SETUP
ROLL COUNTER
SET ROLL LENGTH
---
SET ROLL LENGTH
5.0m
[∧ / ∨]
SET ROLL LENGTH
20.0m
SET ROLL LENGTH
99.5m
[∧ / ∨]
[>]
[>]
SET ROLL ALERT
1m
[∧ / ∨]
SET ROLL ALERT
2m
SET ROLL ALERT
15m
[∧ / ∨]
[∧ / ∨]
 "∗" is displayed on 
the left side of the 
screen for two 
seconds and then 
shifts to near-end 
setting 
automatically
[>]
[>]
[∧ / ∨]
 "∗" is displayed on 
the left side of the 
screen after setting
[∧ / ∨]
[< / >]
[>]
PRINTER SETUP
CUT SHEET COUNTER
SET SHEET PAGES
---
SET SHEET PAGES
10PG
[∧ / ∨]
SET SHEET PAGES
100PG
SET SHEET PAGES
250PG
[∧ / ∨]
[>]
[>]
SET SHEET ALERT
5PG
[∧ / ∨]
SET SHEET ALERT
10PG
SET SHEET ALERT
50PG
[∧ / ∨]
[∧ / ∨]
[>]
[>]
[∧ / ∨]
 "*" is displayed on 
the left side of the 
screen after setting