Epson Stylus Pro 4400 - Rear Manual Insertion Sensor Removal

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 355
6. Release the two tabs securing "Rear Manual Insertion Sensor" and remove
"Rear Manual Insertion Sensor" from "Installation Plate, Detector, Rear".
(Refer to Figure 4-218.)
7. Disconnect the connector from "Rear Manual Insertion Sensor".
(Refer to Figure 4-219.)
Figure 4-218. Installation Plate, Detector, Rear Removal
Figure 4-219. Rear Manual Insertion Sensor Removal
 Route "Rear Manual Insertion Sensor" harness as shown
in Figure 4-219.
 Release the harness tube from the "Installation Plate,
Detector, Rear".
Tabs
Rear Manual
Insertion Sensor
Tube
Connector